combing hair (moistened by hair spray sprayed on the brush) through a stencil hole.
coloring the skin below the arch creates the illusion of a flat bottom line. We're using brow powder where Mother Nature didn't supply brow hair!

Our model loved the new look a different brow shape gave her!

Changing Brow Shape Helps Create Beautiful Looks
	Janet Jackson
	Linda Evangelista
	Claudia Schiffer
	Heather Locklear

Click here for Tips & Tricks

Steps

Before

Moisten brows

Tools: The eyebrowz brow comb/brush combo.
Directions: Remove all cosmetics from the brow, and brush or comb out the brow hair. Dampen the brow hair.

Position the stencil

Tools: An eyebrow stencil in a flat shape. Optional eyebrowz stencil band holder to help hold the stencil in position.
Directions: Lay the stencil down over the brow hair. Slightly lift the stencil & comb hair above the stencil into the stencil hole.

Brush hair through the stencil hole & apply powder to bald areas

Tools: Eyebrowz brow comb/brush combo, extra firm hair spray, Eyebrowz powder and nylon powder brush.
Directions: Spray the brow brush with hair spray. Brush brow hair back towards the tail of the brow. Hair at the front of the brow can be brushed up. Hair spray was given a couple of minutes to dry. Powder was then used to fill in the bald areas of the brow (on the bottom) - again using the stencil as a guide. The powder was brushed slightly over the brow hair to create continuity of color. This ensured no gap between the new bottom edge of the brow and the brow hair.

Done

Get The Shape You Want
Trace Your Shape With Brow Stencils
Choose from 7 pages of brow shapes (click here)
each shape inspired by
a celebrity image

(click here)

Basic Shape Sketch
Stencil Catalogs	soft angled stencil shapes	round stencil shapes	curved stencil shapes	angled stencil shapes	flat stencil shapes

Some Tips & Tricks

Recreating your brow shape is not as hard as you may think. It takes a bit of practise but it is well worth the effort.
If you are starting from little brow hair it is as simple as placing the stencil shape over your existing brows and filling in with powder.
In all cases, we selected new brows that were one step away only from the starting brow. For example, we went from moderate arch to flat, from moderate arch to high arch. We did not try to go to a high arch from a flat brow. We also went from medium thickness to thick and thin. We did not try ultrathin. Thick to ultrathin, for example, would have been too far a stretch without removing hair.
We used a brow powder color similar to the hair color. This makes it as hard as possible for anyone to tell where the hair line ends and new brow area begins.